[djmn]

I'm building a set of platform steps against the corner of the house. I plan on using a modified pedestal method so there will be block and rock right up directly against the house. I'll obviously remove the siding in this area. I removed the deck ledger board and this is the result.
How do I properly flash the area where the steps will be in contact with the house?
You can't really tell but there is about an inch of insullation that protrudes out from the poured concrete foundation. Do I need to build some sort of special J channel flashing to deal with this?
I was thinking of using a self adhesive "ice/water" type flashing. Would I attach that directly to the house/foundation insulation or should I maybe use traditional metal flashing first and then cover it with the self adhesive type?
Anybody deal with this type of stuff on a regular basis?
Thanks

[djmn]

sorry....Here's a closeup

[Pelican]

I would use aluminum flashing. Start at the bottom at grade level and tack a piece into place at the top of the sheet. Then lay a second sheet over the first, overlapping over your nails. Again, tack at the top. I don't think any special forming is necessary.

I don't think I'd use ice and water barrier, a stone could penetrate the membrane and compromise your barrier.

[djmn]

Thanks Pelican,
You're right...I didn't think of a rock penetrating that membrane.
So I think I'll go your route.
Should I cement/seal the area at the bottom of the flashing to prevent any sort of "wicking"?