|
Sorry Keith..havent checked the forum for awhile..been busy.
The two screws were actually on the bottom in the center of the skimmer box. It was completely ridiculous how much time I spent on just 2 stupid screws. I ended up getting longer screws and managed to get one tight...this allowed me to use the screw I was given for the other hole, then I took out the longer screw and the smaller screw went in. Hope that made sense, its late and Im tired. I think small bits of grit can get into the hole to cause a problem on the threads or a small bit of the liner gets in the hole. Whatever it is, its a pain. So far, no leaks!! Maybe I'll post a picture later on a different thread. It turned out pretty nice.
|