|
Yes. We're still working out the kinks with it. It gets it up off the floor but there is still some jiggle that is getting transferred to the roof. We ran air drops through the shop at various points. But we're still using our little floor compressor since we don't have all the problems worked out with the big one.
We put some rubber isolators between the feet of the compressor and the cross beams that are attached to the threaded rod. With too much shake and wiggle, so we then braced it against the wall. It still shakes so I got some spring isolators, which we haven't installed yet. We also have to check to see if the belts are out of alignment and causing the compressor to shake when running. The compressor was in the shop when we bought it so we're working our way backwards removing the problems as we go. I'm hoping we don't discover that the motor is out of alignment. We'll know once we remove the belts.
|